Describe:

1.This is a fan that uses thermal power as an energy source to circulate the hot air from the wood-burning fireplace. There is a thermoelectric module on the fan that acts as a small generator to drive the fan's motor. Electric current is generated when this generator module experiences a heat difference between the top and bottom surfaces. The bottom of the fan heats the bottom surface of the module, while the top of the module is kept cool by the fan's top fins.

2.That is, as long as it is placed on top of the burning stove, it will absorb heat to drive the fan to rotate, thereby blowing the hot air above the wood-burning fireplace directly to the living area, increasing the air circulation in the room and improving the heating efficiency of the stove .

3.The rotation speed of the fan varies depending on the temperature of the wood-burning stove. The higher the stove temperature, the faster the rotation speed. When the furnace temperature is so low that the fire goes out, the rotation speed slows down until it stops rotating.

Caractéristiques:

1. Save fuel, fans distribute heat from the stove to provide better fuel efficiency;

2. Self-generating – no plug – no battery, no need for any battery or power source;

3. Quiet operation;

4. Self-start, adjust speed and stop;

5. Simple and stylish design.

spécification:

Name: Fireplace Fan

Matériel: Alumina

Air volume: 180-210

Feuilles: 6 leaves

Wind speed: 800-1100rpm

Noise: ≦35dB

Température de travail: 60-350°c

Taille du produit: 180*100*190mm

Couleur: 8 colors: noir, or, argent, iron gray, rouge, bronze, rose red, blue

1. Place the stove fan on a smooth, flat surface on the stove top, near the side or back of the chimney.

2. The furnace fan is designed for independent stoves, and the surface temperature of the furnace is between 65℃-C 350℃). Temperatures above this range may damage the fan and generator set.

Product Care:

1. Please read the user manual before using the fan.

2. Please always use the fan on the package.

3. Before using the fan, please check whether the fan is damaged. If the fan is damaged during transportation, please do not install or use the fan.

4. When the fan is working normally, please keep children away from the fan.

5. Please do not touch any part of the fan when the fan is working, if you want to move the fan, please wear protective gloves.

6. When the temperature exceeds 300 degrés, the bimetal thermal insulation device at the bottom of the fan will automatically bend and tilt to protect it.

7. Please use this product with a free-standing stove, not a built-in stove or other insulated top designs.

8. When the temperature is higher than 250 degrés, lift our fan to the upper position of the heat insulation board, so that the fan can reduce heat absorption and effectively protect the fan. Because the open flame temperature of this type of furnace is too high, it needs to be used with a heat shield. At the same time, it is recommended to use a thermometer to monitor the temperature of the furnace.

Package list：

Fireplace Fan x 1pc