spécification:
Nom: SDR active shortwave antenna amplifier board with Shell set
Tension de fonctionnement: 6V~15V DC
FREQ. Rang: 100kHz-120MHz for Aviation bands and frequency modulation. For shortwave signal, it is 100kHz~30MHz.
Gagner: 0~400 (about 40DB)
Antenna board with shell net weight: 52g(exclude battery case and 3 mètres' cable weight)
Shell Size: 105*50*36(MM)
Loop antenna: 304 steel wire, steel wire Φ1.5mm, loop vibrator Φ50-60cm.
Zone de demande: SDR radio, shortwave radio with external antenna port interface.
Below is user's guide:
1. Need get 1pcs 6F22 9V battery for the power supply, peut't use switch power supply as there is EMI.
2. Once get battery and SM cable, antenna loop ready, the other end of the SM cable insert into radio external port interface or SDR receiver's input port.
3. Switch on and the LED light on means power on.
4. Switch the gain button DX/Local to find best effect position, clockwise gain bigger, counterclockwise gain smaller. Entre-temps, adjust the antenna ring's position too to get better signal.5. The antenna only for receiving signal, not for issuing.
Taper 1: SDR with 3 meters cable
1. Finished board with shell x 1pcs with 6F22 battery case (sans batterie).
2. SMA-J male to SMA-J male (3 mètres) cable x 1pcs
3. Loop antenna x 1pcs (304 steel wire, steel wire Φ1.5mm, loop vibrator Φ55cm)
Taper 2：3.5MM with 3 meters cable
1. Finished board with shell x 1pcs with 6F22 battery case (sans batterie)
2. 3.5MM male to SMA male (3mètres) cable x 1pcs
3. Loop antenna x 1. (304 steel wire, steel wire Φ1.5mm, loop vibrator Φ55cm)
Taper 3: BNC with 3 meters cable
1. Finished board with shell x 1pcs with 6F22 battery case(sans batterie).
2. SMA-J male to BNC-J male (3 mètres) cable x 1.
3. Loop antenna x 1pcs (304 steel wire, steel wire Φ1.5mm, loop vibrator Φ55cm)
Taper 4: SDR with 6 meters cable
1. Finished board with shell x 1pcs with 6F22 battery case (sans batterie).
2. SMA-J male to SMA-J male (3 mètres) cable x 1pcs
3. Loop antenna x 1pcs (304 steel wire, steel wire Φ1.5mm, loop vibrator Φ55cm)
Taper 5：3.5MM with 6 meters cable
1. Finished board with shell x 1pcs with 6F22 battery case (sans batterie)
2. 3.5MM male to SMA male (3mètres) cable x 1pcs
3. Loop antenna x 1. (304 steel wire, steel wire Φ1.5mm, loop vibrator Φ55cm)
Taper 6: BNC with 6 meters cable
1. Finished board with shell x 1pcs with 6F22 battery case(sans batterie).
2. SMA-J male to BNC-J male (3 mètres) cable x 1.
3. Loop antenna x 1pcs (304 steel wire, steel wire Φ1.5mm, loop vibrator Φ55cm)
Avis
Il n’y a pas encore d’avis.