150MM Rotary Chimney Brouss, Séchoir…

Special note:

* In this link, the quality of 570mm long rods is better than that of 410mm and 600mm long rods.

*570mm long rods has better strength and toughness！

*I strongly recommend prioritizing the selection of 570mm long rods.

Caractéristiques:

*100% Tout neuf, Haute qualité, Shipped in 48 heures

*Matériel: Pe, Pennsylvanie, Nylon, Fer

*The pole is connected by a buckle. The rod is flexible and can easily move along the curved pipe

*This brush is used to clean chimneys, dryer pipes, tuyaux longs, toits, inner walls of fireplaces, etc..

Comment utiliser：

1. Connect a sufficient number of poles as needed;

2. Install the brush head on the pole, (if you use a power drill, go ahead and install the hex pole);

3. When you start off go slow and clean out 2-3 feet at a time and pull the brush back towards you to bring all the dust junk back to or down to you. Going vertical to push the junk out won’ça ne marche pas. However horizontal may work for you.

4. Get someone to do the drill work for you as you guide the rod and brush in and out of the pipe. As you go in pull it back and forth and then go in further. Once you have done about 3 feet pull it all back out to bring the junk back to you.

5. WEAR A MASK !! There will be dust everywhere. It will smell like fabric softener everywhere.

6. Prudence: Rotate brush/rod(s) assembly only in a clockwise direction. Reversing the direction could cause the brush head or rod(s) to detach inside the duct.

AVERTISSEMENT: Never force the brush/rod assembly through the duct! If it should become jammed, pull assembly away from constricted area a few inches (still rotating in a clockwise direction) then slowly push forward.

AVERTISSEMENT: Please do not bend the rod connecting the electric drill. If you have to bend, the bending angle should not exceed 30 °, and please turn it at a very, very slow speed. Sinon, the product will be damaged by you!

AVERTISSEMENT: When the length of the pole is greater than the length you need to use. Please remove the extra poles. Sinon, the redundant rods will be twisted together due to the rotation of the electric drill, and the rods will be damaged!

spécification:

*Please understand that there will be a little error in manual measurement.

*The color of the rod is beige and white. Two colored poles are sent randomly. Product quality is the same. Veuillez comprendre que!

*I recommend 410mm or 570mm long rods. Because, they don’t have to be bent during transportation. The 600mm long rod needs to be bent to transport it.