Knochenmagnelwinger, Garnwickler zum Häkeln, Häkelhaken von Spitzen

Produktbeschreibung

Paket:

Garnkugel Wickler * 1

Stitch Knitting Needles * 53

Size of wool winder:

Width is 4.72inch/12cm, height is 4.13inch/10.5cm

Detailed Usage

Set spindle into geared base by aligning notches. While holding geared base, turn spindle clockwise to secure. Clamp the ball winder to table or other support using integral clamp, clamp will work on thickness up to 1.5“. Clamp is controlled by turning the red knob. Rotate yarn guide so loop end faces upward. Pull it out as far as it will go, locking it into working position as shown. Yarn to be wound should be supported on a swift to allow uniform transfer. Feed the end of yarn through the yarn guide and secure in a notch on top of the spindle. Yarn is easily placed through the guide by simply wrapping it in a clockwise direction around the end coil. Turn the handle clockwise, forming the yarn into a ball. The finished ball can be withdrawn from the winder by simply pulling off from the underside of the ball. Yarn from the ball can be used by withdrawing from the center core or from the outer edge.

Perfect for a variety of uses

We’ve fully stocked this knitting tool kit with a crochet yarn winder and knitting needles to offer convenience and versatility needed for professional or beginner DIY use. Now you can use these knitting supplies when making a sweater. Grab your own today, and engage your creative instincts.

YARN WINDER and LACE CROCHET HOOKS: Größe: Width is 4.72inch/12cm, height is 4.13inch/10.5cm. 8 sizes lace crochet hooks, stitch markers, stitch ring markers, plastic locking stitch markers, cable stitch holders, and yarn needles.
GOOD TOOL TO SAVE TIME: Ideal for winding loose yarn into immaculate, well-kept balls by simply turning the crank, which can get your knitting and crocheting supplies organized easily. The operation is simple, and the yarn ball can be made in a few minutes, saving you a lot of time.
HÖHENVERSTELLBAR: This component at the bottom is used to attach the yarn winder to a table/surface. You can spin the red button left and right to make a bigger space when attached to the table.
FIXED YARN: This cylinder at the top has 2 indents on each side to attach the end of your yarn, once you have it through that metal circle on the side. You’ll want to put that yarn end through each indent, leaving a small yarn tail.
A tip when winding, hold the yarn near your skein/hank, usw. If you don’t you will end up with a loose yarn cake. It won’t hold its shape. You don’t want to leave a long yarn tail, it could get caught in the bottom part that spins.