Descrizione del prodotto

NOTICE

This bender is only suitable for 3/8″ & 1/2″ O.D. soft copper/aluminum tubes! It is NOT suitable for EMT or Stainless Steel tubes! Soft tubes can be bent directly, but hard tubes need to be annealed to soften before bending! Please note that the nominal size of 1/2″ type M copper pipe is actually 5/8″ outside diameter. Therefore, this bender CANNOT bend type M copper pipe with a nominal size of 1/2″.

ONLY for tubings, NOT for pipes!!!

FQA

1. Can this bend type 1/2″ size type M copper pipe?

NO, it can’t. Please note that the nominal size of 1/2″ type M copper pipe is actually 5/8″ outside diameter. This bender is only suitable for 3/8″ & 1/2″ O.D. soft copper pipes. Therefore, this bender CANNOT bend type M copper pipe with a nominal size of 1/2″.

2. What kind of tubes is this bender suitable for?

This tubing bender is ONLY suitable for soft copper/aluminum tubes.

[Nota: Stainless steel tubes, iron tubes, EMT tubes and other tubes are not applicable!]

3. What wall thickness is it suitable for?

This tube bender is suitable for tubes with a wall thickness of 0.6-2mm. If the wall thickness <0.6mm, the tube may be damaged.

4. Can it bend hard copper tubes?

SÌ, but you need to anneal the tube to soften it before bending.

5. How to judge whether the tube O.D. is suitable?

The upper handle of the bender has two holes for measuring the O.D. of the tube. (Nota: if the O.D. is too large, it cannot be used!)

Aggiungi al carrello

Aggiungi al carrello

recensioni dei clienti

4.3 fuori da 5 stelle

115

4.5 fuori da 5 stelle

63

Prezzo

$35.99$35.99

$58.99$58.99

Applicable tube O.D.

3/8″, 1/2″

5/8″

Bending angle

0-180°

0-180°

Applicable wall thickness

0.6~2mm

0.8~1.5mm

Peso

1.05kg

2.12kg

[Parameters] – Applicazione: only for copper / aluminum tubes; applicable tube O.D.: 3/8″、1/2″; applicable tube wall thickness: 0.6mm-2mm; bending radius of 10mm: 23mm (3/8″), bending radius of 12mm (1/2″): 35.8mm; bending angle: 0~180°.

[Alta qualità] – The tube bender is forged from high-quality aluminum alloy, which is light and durable. (NOTA: if the pipe wall thickness<0.6mm, it will cause deformation of the tube.)

[2-in-1] – This tubing bender tool is a 2 In 1 tool and will fit 3/8″, 1/2″ tubes, which is convenient for different size tube bending and save cost.

[Humanized Design] – (1)The manual bender uses the principle of leverage, with which you can easily bend the tubes. (2)The round hole of the upper handle can test the size of the copper tube. (3)The bender is only about 1kg, light and portable.

[Wide Applications] – This tubing bender is suitable for HVAC, air conditioning, and refrigerator pipe repairs.