DIY Efoil Kit Foil SUP Kayak Boost Kit 6384 140KV Waterproof Motor +16…

DIY Efoil Kit Foil SUP Kayak Boost Kit 6384 140KV Waterproof Motor +160A Fully Waterproof ESC + MTSKR1905WF Waterproof Remote

1. MTO6384-140-WPC Waterproof 6374 Motor

MTO6384-140-WPC 6384 Outrunner Motor
Fully Waterproof (can be immersed in water)
Max Torque 8.8N.M;
Motor KV: 140 (RPM/V) KV can be customized.
Shaft: No output shaft
máx.. Actual: 100A
Input Volt: 3-12Lipo cell
máx.. Output Watt: 5000W.
Motor size: 62.6*86milímetros
Motor next weight: about 1.1kg
Wire length: about 1meter
Without Hall Sensor
Solicitud: For Wing foil, wind surf foil, sup foil board, electric foil board, kite foil board, underwater thruster, underwater robot, ROV, Electric Kayaks, etc..

Our advanced waterproof technology:

Rotor magnets with anti-oxidation and anti-rust treatment;
Stator with insulation paint;
Coil Copper wires with transparent insulating varnish;
Stainless Steel bearing.

Stainless Steel Bearing:
Because seawater is corrosive, after some time use may get rust, need to wash with fresh water everytime after use, and keep
the motor all dry, so to expand lifespan.

2. MICP27F Folding Propeller

Propeller Model: MICP27F
Material: Nylon Powder
Blade: 2 folding Blades
Color: Negro
Mounting Holes: 8xM4
Max Rotation Diameter: 165mm/6.5'' (Approx.)
Height: 32mm/1.25'' (Approx.)

3. Maytech New 32Bit 160A ESC Waterproof Speed Controller (Non-VESC) With Progcard Higher power and more easier to be programmed.

Model No.: MTSF160A-WP32
Waterproof Rank: IP68
Cont Current: 160A
Peak Current (at 10S): 180A
Voltaje de entrada: 6-14S Lipo (22.2V-58.8V)
With 5V/0.5A BEC
Tamaño: 92*46*23milímetros
Net Weight (without wires): 180gramo; including wires 510g ( about 15cm wires for motor, 1-1.15m for battery)

Progcard32 for programming the ESC

Solicitud: efoil, underwater drone, foil assist, surf assist, ROV, etc..

4. MTSKR1905WF V2 V3.0 Waterproof Remote with Receiver

Model no: MTSKR1905WF
Waterproof Rank: IP67 with 2 layers nanometers coating and waterproof glue on PCB and screen
Control Mode: Esk8/ Esurf

Signal Format: Standard PWM (PPM), output range from 1-2ms, which correspond to ESC/VESC_TOOL Compatible controller throttle output range from 0%-100%.

PWM Signal Output Range: 1ms-2ms for throttle no brake in Esurf mode; 1.5ms-2ms for throttle, 1.5ms-1ms for brake in Esk8 mode.

UART: Acceptable
Double Source Power Supply: Accept 5V power by ESC built-in BEC or extra 5V power
Display: Remote and battery power, signal strength, throttle and brake percentage, RPM, velocidad, mileage; Actual, Voltaje,
Firmware Updatable: Sí
Control Pump: Sí (Relay Switch)
Control Light: Sí (Transistor Switch)
Set Safety Button: Sí
Cruise Control: Sí, With in Esurf Mode
Brake: Sí, With in Esk8 Mode
Carga inalambrica: Sí
What comes in the package: Charging Pad, receiver, wristband, 3pcs dupont cable

Compatible Controllers: VESCTOOL Compatible/ Focbox/ Other PWM ESCs that has same signal output range with the remote.

Solicitud: Esurf, Efoil, electric hydrofoil, electric surfboard, electric skateboard/ elongboard/ mountainboard, electric paraglider, etc.

Our advanced motor waterproof technology:

Rotor magnets with anti-oxidation and anti-rust treatment;
Stator with insulation paint;
Coil Copper wires with transparent insulating varnish;
Waterproof stainless steel bearing.

Some other waterproof motors stator and rotor are full filled with black glue. This kind of black glue may expand when motor heats up, it will expand, then distance between the stator and the rotor will be very small. If rotor and stator scraches each other , it will affect the life of the motor.
Moreover, if the rotor and stator are full filled with glue, the motor will heat up more easily and the motor power efficiency is poor.

Our waterproof 6374 motor insulating paint is harder than above normal black glue, and even if there is heat, it will not expand to affect the space between the stator and the rotor. It ensures longer motor life!